![]() ![]() NM-4T, has 4 Serial ports for WAN connections.NM-16ESW, is a switching module with 16 FastEthernet ports and provides some basic switching functionality. ![]() There will be a certain amount of slots enabled so you can choose between the following types of interfaces available. This is the window that comes next and where you are going to be adding interfaces to your Router. Now comes a tricky part if you don’t know what you are doing. There will be the default/minimum RAM needed for it to run properly already set, but if not, I’ll leave a link where you can check how much RAM you need.Ĭheck the minimum RAM needed for every Cisco IOS device here. In the next window, you will have to set the RAM you will dispose of for this virtual device (Router). ![]() I used a Cisco 3745 router, and it automatically detected it (Platform). Once you have selected the IOS image you want, click on Next and you will see the following window. In the new window, go to Browse and go to the folder where you keep the IOS images. Once the new window prompts, go to Dynamips > IOS routers and then click on New.Īnother window will prompt, which is like a Wizard, just follow the steps and click Next until you’re done (I will guide you through anyway). The current version of GNS3 as of this post is 2.1.21. Practicing for your Cisco certifications? Here you will learn how to add cisco ios images in GNS3 in a few minutes so you can start your labs and get better. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |